Table of Contents
Advertisement
INTERIOR LIGHT
The interior light allows you to view the unit's contents.
When the switch is in the "OFF"
position,
the light will come on only
when the door is opened.
In the "ON"
position,
the light remains on continuously.
ELECTRICAL
SHOCK
HAZARD
]
Failure to disconnect
the power
cord when changing
the light bulb
I
may result in electrical
shock.
LIGHT BULB REPLACEMENT
This unit uses a 15-watt appliance
bulb with an intermediate
base located
inside the light shield.
The light shield is on the back of the unit and is
held in place by the use of three screws. Remove the three screws and
light shield to remove the light bulb.
DO NOT replace the bulb with a
bulb higher than 15 watts.
ENERGY SAVING TIPS
• Reduce
door openings.
• Close the door as soon as you can.
• Keep the coils on bottom
of the refrigerated
beverage
center
clean.
• Adjust
the temperature
control
to a warmer
setting
when practical.
• Do not put hot foods
in the refrigerated
beverage
center.
• Install unit away from the stove or other
heat sources.
CLEANING
AND MAINTENANCE
Any piece of equipment
works better
and lasts longer
when maintained
properly
and kept clean.
Condenser
The condenser
tubing
inside the cabinet
does not require frequent
cleaning;
however,
satisfactory
cooling
depends
on
adequate
ventilation
over the coils.
Be sure that nothing
obstructs
the required
air flow openings
in front of the cabinet.
Spiders
and insects can nest in and around the refrigerated
beverage
center causing
damage
to the unit.
Frequently
brush or vacuum
lint and dirt from the condenser
coils for efficient
performance
by unscrewing
the grill on the bottom
front of cabinet.
Cabinet
The cabinet can be washed
with mild soap and water and thoroughly
rinsed with clear water.
Never use abrasive scouring
powders.
Interior
Wash interior compartment
with mild soap and water. Do not use abrasive powder, solvent, polish cleaner or undiluted
detergent.
Stainless Steel Parts
All stainless steel parts should be wiped regularly with hot soapy water. Use a liquid cleaner designed for stainless steel
when soapy water will not do the job.
Do not use steel wool, abrasive cloths, cleansers, or powders.
Do not permit citrus
or tomato juice to remain on stainless steel surfaces, as citric acid will permanently discolor stainless steel.
Brass Parts
CAUTION:
All brass parts are coated with an epoxy coating.
DO NOT USE BRASS OR ABRASIVE CLEANERS ON THE
BRASS PARTS. All brass parts should be wiped regularly with hot soapy water. When hot soapy water will not do the job,
use every day non-abrasive household cleaners.
- Quick Links:
- Specifications & Dimensions
Hide quick links:
Advertisement
Table of Contents
