Table of Contents
Advertisement
FINAL PREPARATION
1. Some stainless steel parts may have a plastic protective wrap which must be peeled off. The interior of the refrigerated
beverage center should be washed thoroughly with hot, soapy water, rinsed and wiped dry to remove film residue and any
installation dust or debris before being used. Solutions stronger than soap and water are rarely needed.
2. All stainless steel parts should be wiped with hot soapy water. If buildup occurs, do not use steel wool, abrasive cloths,
cleaners, or powders. If it is necessary to scrape stainless steel to remove encrusted materials, soak with hot, wet cloths to
loosen the material, then use a wood or nylon scraper. Do not use a metal knife, spatula, or any other metal tool to scrape
stainless steel; scratches are almost impossible to remove.
10
OPERATING INSTRUCTIONS
Setting the Controls
The total available temperature range of the indoor unit is from 39 - 42
available temperature range of the outdoor unit is from 33 - 35
selected, the cooler temperature within the unit. Initially set the control knob midway between the numbers. Allow at least 48
hours for the unit to stabilize before making any adjustments to the initial setting.
FOR OUTDOOR UNITS - it is recommended that in temperatures above 110
off. The normal operating range for the unit is between 60
General Tips and Suggestions
•After making a temperature adjustment, allow 24 hours for your refrigerated beverage center to reach a new temperature
setting.
•The motor will start and stop often. It must do this to maintain the temperature setting.
•Unplug the refrigerated beverage center before working on anything with the electrical system.
•Exercise caution when sweeping, vacuuming, or mopping near the front of the unit. Damage to the grill and/or the light
fixture switch can occur.
INTERIOR LIGHT
The interior light allows you to view the unit's contents. When the switch is in the "OFF" position, the light will come on only
when the door is opened. In the "ON" position, the light remains on continuously. NOTE: Outdoor units do not have a light
switch.
WARNING
Failure to disconnect the power cord when changing the light bulb
may result in electrical shock.
LIGHT BULB REPLACEMENT
This unit uses a 15-watt appliance bulb with an intermediate base located
inside the light shield. The light shield is on the back of the unit and is
held in place by the use of three screws. Remove the three screws and
light shield to remove the light bulb. DO NOT replace the bulb with a
bulb higher than 15 watts.
ENERGY SAVING TIPS
•Reduce door openings.
•Close the door as soon as you can.
•Keep the condenser coils on bottom of the refrigerated beverage center clean. (See "Cleaning and Maintenance".)
•Adjust the temperature control to a warmer setting when practical.
•Do not put hot foods in the refrigerated beverage center.
•Install unit away from the stove or other heat sources.
0
F (4.0
-
- 5.6
0
C) to 54 - 56
0
F (12 - 13
0
C). The total
0
F (0.5
-
- 1.1
0
C) to 54 - 56
0
F (12 - 13
0
C). The higher the number
o
F(43
o
C) and below 40
o
F (4.4
o
C) the unit be shut
o
F (15.6
o
C) and 100
o
F (37.7
o
C).
ELECTRICAL SHOCK HAZARD
11
Screws
Light
Shield
- Quick Links:
- Troubleshooting Chart
Hide quick links:
Advertisement
Table of Contents
