Interior Light; Led Light Replacement; Operating Instructions - Viking Designer DFRD144D Use & Installation Manual

OPERATING INSTRUCTIONS

General Tips and Suggestions
•After making a temperature adjustment, allow at least 24 hours for your unit to reach a new temperature setting.
•The motor will start and stop often. It must do this to maintain the temperature setting.
•Unplug the unit before working on anything with the electrical system.
•Exercise caution when sweeping, vacuuming, or mopping near the front of the unit.
•Avoid leaning on the drawer fronts. You may bend the drawer slides or tip the unit.
Setting the Controls
The temperature of our drawer unit ranges from 32
temperature can be adjusted using the control panel located on the inside of the top
drawer. To change the temperature setting, press the warmer or cooler pads until the
display shows the desired temperature. After a few seconds the display will return to
the actual temperatures. To change from Farenheit to Celsius, simply press the warmer
and colder keypads simultaneously. The display will change within a few seconds.
The on/off key pad stops and starts the cooling of the unit. This can be used when
your drawer refrigerator will not be used for extended periods of time. The LED light
will continue to operate when the drawers are opened as long as the unit is connected
to a power source.
At time of initial start up the control panel display will show "OR" for "Out of Range"
until the unit reaches the desired temperature.

INTERIOR LIGHT

WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect the power cord when changing
the light bulb may result in electrical shock.

LED LIGHT REPLACEMENT

1. Unplug unit.
2. Remove drawers. (This is not required to remove the light, but will provide better access). See Figures 1 through 3
in Full Overlay Panel Installation on page 6.
3. Remove old lights. Use 2 small, thin bladed screwdrivers or putty knives to press in the locking tabs on the lens
housing. (Figures 4 and 5). With the locking tabs depressed, pull downward (Figure 6), the light housing will pop
free. Disconnect the wire lead by pulling straight out from the connector. Connect wire lead to new light and re-
install into metal housing. The light will only fit in the housing with the locator tabs pointing to the front of the unit.
4. Re-install drawers.
5. Plug in unit.
Figure 4
F to 47
o
Figure 5
F (0 C to 8 C). The
o o o
Never pour liquids directly onto light assembly
Figure 6
9
01
34 F
o
OR
CAUTION
C
o