7.1.3.2 Replacing Heater / Fan Assembly
1)
To replace either upper or lower heater/fans, remove the 2 hex screws on each end of end of each
assembly (See figure 12.15 & 12.17).
2)
Upper compartment: Disconnect the Molex connection at top left hand corner (See figure 12.21).
3)
Lower compartment: The Molex connector for the lower heater/fan is located behind the heater/
fan assembly. After removing the hex head screws, pull assembly away from the liner, reach
behind and disconnect at Molex connector.
4)
Reverse above steps to replace.
SEE PHOTO SECTION FOR REFERENCE TO ABOVE MENTIONED FIGURES
2010 - Viking Preferred Service
41
SMR-0005