Upvel UP-308FEW User Manual page 39

UP-308FEW / UP-316FEW
STP Port Settings table
Port No.: Choose one port of the Switch for further management.
Priority: Decide which port should be blocked by setting its priority as the lowest. Enter a
value between 0 through 240. The value of priority must be the multiple of 16.
RPC: The cost of the path to the other bridge from this transmitting bridge at the specified
port. Lower values should be assigned to ports attached to faster media, and higher values
should be assigned to ports with slower media. Enter a value between 1 through 200000000.
The default value is Auto.
STP Port Status table
Port No.: The switch port number of the logical STP port.
RPC: Root Path Cost. For the Root Bridge, it is zero. For all other Bridges, it is the sum of the
Port Path Costs on the least cost path to the Root Bridge.
Priority: The current priority for each port.
State: The current STP port state. The port state can be one of the following: Designated
port, Root port or Blocked port.
Status: The current STP port status. The port status can be one of the following: Forwarding,
Disable, Listening, Blocking, Learning.
Designated Bridge: ID of the STP Bridge which designated the root port.
Designated Port: Port number of the bridge from where the bridge designated the root port.
User Manual 39