Upvel UP-308FEW User Manual page 27

VLAN Member Setting in Tag Based Mode
In Tag-based Mode, you need to define and configure VLAN groups. Assign the VLAN ID,
select the VLAN member ports, assign the PVID and check the configuration result.
In the following figure, ports 1~7 are in the same VLAN group.
The port 2 tag VID number is 123.
• VLAN ID (VID)
For the handover to other switches to take place smoothly, the VLAN IDs (Numbers) need
to be like in the rest of your network.
On the other switches there may be was an option to set the names. These are just for
your reference. Only the numbers are important!
Add: Enter a VID, select the VLAN member for this entry and then press this button to add
a VLAN entry to the table. The available VID range is 1~4094.
Delete: Select a VID in the table and then press this button to remove a VID entry from the
table. After deleted, the VLAN and its member port settings are cancelled.
Update: This is for modifying the existing VLAN settings. Select the VID, the settings will
be displayed below, change the settings and then press the Update button to update the
settings.
• VLAN Member Port
Select the VLAN Member here.
User Manual
UP-308FEW / UP-316FEW
27