Table of Contents
Advertisement
8.4
Plug the dispensing tap cable connector into the Aquatap heater.
8.5
Plug the Aquatap into a 13A socket.
8.6
If a chiller unit is fitted to the dispenser, site the chiller near to the Aquatap heater, make
sure that the chiller level tube is facing outwards to allow servicing.
8.7
Connect the water supply to the chiller as per fig 8. The chilled water supply via a
6mm pipe from the chiller should be connected to the "cold outlet" side of the Aquatap, a
6mm to 10mm fitting is supplied for ease of use.
8.8
The dispenser tap chilled hose should be connected to the "outlet" pipe of the chiller unit
The dispenser tap ambient hose should be connected to the "outlet" of the Aquatap and
secured in place with the pipe clamps supplied.
FIGURE 8: TAP MOUNTING (BOIL & CHILL)
(NOTE: DRIP TRAY/SINK NOT SHOWN FOR CLARITY)
DISTANCE BETWEEN TAP AND HEATER
AS SHORT AS POSSIBLE TO ENSURE
CONNECTING PIPES RISE CONTIUOUSLY
DISPENSER CABLE
COLD TAP
OUTLET
CLAMP
HOSE 6mm
+ INSULATION
WHITE HOSE
HOT TAP
TAP
OUTLET
CONNECTOR
HOSE
TAP
VENT
HOSE
CLAMP
1.5mm² 3 CORE HO5 VV-F
SHEATHED CABLE
3 BAR
PRESSURE REGULATOR
SUPPLIED
CHILLED WATER
SUPPLY
FLEXIBLE
ISOLATING
HOSE
VALVE
TEMP
SET
POWER
SWITCH
WATER IN
8mm PIPE
MINIMUM DISTANCE
150mm
BETWEEN UNITS
MAINS
WATER
SUPPLY
CHILLER
UNIT
ICE BANK
LEVEL
INDICATOR
13
Advertisement
Table of Contents
