Table of Contents
Advertisement
8.0
INSTALLATION – DISPENSING TAP CONNECTION
8.1
The hot supply hose should be connected to the OUTLET hose spigot of the Aquatap
water heating unit. The hose should rise continuously from the heater to the tap
without kinks or twists. If necessary it can be cut to a shorter length, but it should
never be lengthened. The hose should be secured in place on the spigot using the clamp
provided.
Warning: Only use the hose supplied with the unit or a WRAS approved hose.
Spare hose and clips can be ordered, product code 95607364.
8.2
The VENT hose should be connected to the VENT hose spigot of the Aquatap water
heating unit. The hose should rise continuously (vertical) from the heater to the tap
without kinks or twists. If necessary it can be cut to a shorter length, but it should
never be lengthened.The hose should be secured in place on the spigot using the clamp
provided.
8.3
The Ambient hose should be connected to the cold hose spigot of the Aquatap water
heating unit. The hose should rise continuously from the heater to the tap without
kinks or twists. If necessary it can be cut to a shorter length, but it should never
be lengthened. The hose should be secured in place on the spigot using the clamp
provided.
FIGURE 7: TAP MOUNTING (BOIL & AMBIENT)
(NOTE: DRIP TRAY/SINK NOT SHOWN FOR CLARITY)
12
DISTANCE BETWEEN TAP AND HEATER
AS SHORT AS POSSIBLE TO ENSURE
CONNECTING PIPES RISE CONTINUOUSLY
DISPENSER CABLE
CLAMP
WHITE HOSE
HOT TAP
OUTLET
HOSE
CONNECTOR
TAP
VENT
HOSE
AMBIENT
OUTLET
HOSE
CLAMP
1.5mm² 3 CORE HO5 VV-F
SHEATHED CABLE
FLEXIBLE
HOSE
COLD WATER
SUPPLY
Advertisement
Table of Contents
