Using The Clock And Timer - GE JB970 series Owner's Manual And Installation Instructions

Using the clock and timer.

Make sure the clock is set to the
correct time of day.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes.
16
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
To Set the Timer
Press the KITCHEN TIMER
ON/OFF pad.
Press the number pads until the
amount of time you want shows in
the display. For example, to set 2
hours and 45 minutes, press 2, 4
and 5 in that order. If you make a
mistake press the KITCHEN TIMER
ON/OFF pad and begin again.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by pressing
the KITCHEN TIMER ON/OFF pad, then
press the number pads until the time you
want appears in the display.
To Cancel the Timer
Press the KITCHEN TIMER ON/OFF
pad twice.
Press the CLOCK pad.
Press the number pads.
Press the START pad until the
time of day shows in the display.
Press the START pad.
When the timer reaches :00 , the
control will beep 3 times followed
by one beep every 6 seconds until
the KITCHEN TIMER ON/OFF pad
is pressed.
The 6 second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
pressing the KITCHEN TIMER ON/OFF pad
and then pressing the number pads to
enter the new time you want.