GE JB970 series Owner's Manual And Installation Instructions page 38

Installation of the range.
Read these instructions completely and carefully.
Anti-Tip Bracket Installation
Typical installation of anti-tip bracket attachment to wall.
An Anti-Tip bracket is supplied with instructions
for installation in a variety of locations. The
instructions include a template, a parts list and a
list of tools necessary to complete the installation.
Read the Important Safety Information and the
instructions that fit your situation before
beginning installation.
Leveling the Range
The range must be level. Leveling feet are located
at each corner of the base of the range. Remove
the storage drawer and using channel locks,
rotate the leveling feet in and out as required to
level the range. (For instructions on how to
remove and replace the storage drawer, see
the Care and cleaning of the range section.)
Final Check
Be sure all range controls are in the OFF position
before leaving the range.
38
Bracket
Wall plate
Screw must
enter wood
or metal
WARNING
Range must be secured by Anti-Tip bracket
supplied.
See the installation instructions to install
(supplied with bracket).
Unless properly installed, the range could be
tipped by stepping or sitting on the door. Injury
might result from spilled hot liquids or from
the range itself.
One of the rear leveling feet will engage the
Anti-Tip bracket (allow for some side to side
adjustment). Allow a minimum clearance of 1/8"
between the range and the leveling foot that is to
be installed into the Anti-Tip bracket.
Check the range for proper installation into the
Anti-Tip bracket by removing the storage drawer
and inspecting the rear leveling leg. Make sure it
fits securely into the slot.