Rev. 12/23/2014
11. Attach the shift tray feeler [A].
⇒
12. Attach the sheets [A] at the edge of the paper output cover.
IMPORTANT: Make sure to attach the Mylar as shown in the photo below. This is to prevent
curling when the paper lands in the tray.
-
The Mylar's top edge should be 0-2.5mm from the top edge of the paper output cover, i.e.
between the two red lines.
-
The Mylar's side edge should be flush against the side of the cover, i.e. along the yellow
dotted line.
13. Attach the paper output cover and main power switch cover, and close the duplex unit.
14. Turn the power switch ON.
15. Check that paper output to the shift tray can be selected at the operation panel, and check the
operation.
D146/D147/D148/D149/D150
2-
82
Internal Shift Tray SH3070
SM