Steam Cleaning - AEG BS9354001 User Manual

• Clean all accessories after each use
and let them dry. Use a soft cloth with
warm water and a cleaning agent.
• If you have nonstick accessories, do
not clean them using aggressive
agents, sharp-edged objects or a
dishwasher. It can cause damage to
the nonstick coating.
12.2 Removing the shelf
supports
Before maintenance, make sure that the
appliance is cool. There is a risk of burns.
To clean the appliance, remove the shelf
supports.
1. Pull carefully the supports up and out
of the front catch.
2. Pull the front end of the shelf support
away from the side wall.
3. Pull the supports out of the rear
catch.
Install the shelf supports in the opposite
sequence.

12.3 Steam Cleaning

Remove as much dirt as possible
manually.
Clean the inner door glass with a soft
cloth with warm water and a cleaning
agent.
Remove the shelf support to clean the
side walls.
EURO Appliances - euappliances.info
1
3
2
CAUTION!
For a better performance
you should start the cleaning
function when the appliance
is cool. Check the residual
heat.
Always use the function after cooking
with steam.
When the function is active, the lamp is
off.
1. Put 400 ml of water mixed with 3
tablespoons of vinegar (without
herbs) directly into the steam
generator.
2. In the menu activate the function:
Steam Cleaning.
The display shows the duration of the
function (33 minutes).
An acoustic signal sounds when the
programme is completed.
3. Touch a sensor field to deactivate
the signal.
4. Wipe the internal surface of the
appliance with a soft sponge.
5. Remove the remaining water from
the steam generator.
6. After cleaning keep the appliance
door open for approximately 1 hour.
Wait until the appliance is dry. To
speed up the drying you can heat up
the appliance with hot air at
temperature 150 °C for
approximately 15 minutes.
You can get maximum effects of the
cleaning function if you manually clean
the appliance immediately after the
function ends.
Use the function two times if the level of
dirt is high. Make sure that the appliance
is cool before you activate the second
cycle.
12.4 Decalcification of the
Steam generator
1. Put 250 ml of water mixed with 3
tablespoons of vinegar directly into
the steam generator.
2. In the menu choose: Assisted
Cleaning.
3. Activate the function: Decalcification.
47
ENGLISH