Table of Contents
Advertisement
OPC6115/6315
3.4 Mounting procedure
Use the drilling template to drill holes according the mounting illustration in the control panel with the
specified threading. Insert the upper screws half way into the control panel and hang the device on the
mounting links. Tighten the screws and insert the rest of the screws.
Warning:
The device must be switched off before connecting or disconnecting any cables in
order to prevent damage to the electronics!
The device may only be switched on after acclimatising to the ambient temperature
in order to avoid condensate accumulation. Make sure to meet the permissible
voltage requirements for this device.
After switching off and before switching on you must wait for at least 5 seconds.
Note:
The device is connected to the power supply using a lead out terminal with a
screw connection. A ground connection does not have to be made, because
the grounding conductor of the device plug or supply connection serves this
purpose. If additional grounding conductors are attached to a grounding
screw, a wire diameter of at least 2.5 mm² is specified.
© ads-tec GmbH • Heinrich-Hertz-Str. 1 •72622 Nürtingen
15
Advertisement
Table of Contents
