Mounting - ADS-tec opc6115 User Manual

OPC6115/6315

3 Mounting

3.1 Mounting Options
This device is intended for integration into switch panels or switching cabinets. In order to allow for a
safe installation and operation (connector access), these switch panels or control desks must be
accessible from the back. The device can be integrated into switching cabinets with a wall thickness of
2..6 mm. We recommend a minimum of 3 mm for correct installation with an IP65 front protection class.
Warning:
To avoid overheating in operation: The device must not be exposed to direct
radiation by sunlight or any other light or heat source.
If the device is integrated in a panel, casing or similar enclosures, you must ensure
that no heat accumulation builds up. The maximum permissible environmental
temperature must never be exceeded.
Devices including a data drive must only perpendicularly be integrated. Any
deviation must be agreed with ads-tec.
The IP65 protection class is only achieved after correct installation.
If the device is delivered with a CD/DVD-ROM drive, sufficient space (approx.
130mm) must be provided on the left-hand side if viewing the drive from the front,
in order to allow proper opening of the drive.
Note:
When selecting the enclosure for integration, the power dissipation total of
the system including that of all integrated PCBs must be taken into account.
The enclosure must be calculated in such a way that the maximum
environmental temperature is not exceeded in any case.
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen
10