3. INITIAL SETTINGS
FORMAT: Select sentence format. [IEC]: Sentences for IEC 61162 Ed.4 received.
[IEC+NMEA]: Sentences for IEC 61162 Ed.3 and NMEA received. [IEC+NMEA-EM]:
Sentences for IEC 61162 Ed.3 and NMEA received. However, GNS/GLL/RMC sen-
tences with a mode indicator of E or M are not received.
CH TABLE: Select channel table from [WRC-7] or [WRC-12]. Select [WRC-12] usu-
ally. If frequency clearance is not revised from country to country, select [WRC-7].
TX PWR (FREQ)
* Shown for FS-5075 only
TX power can fluctuate on certain frequencies depending on antenna location. If this
occurs, adjust the TX power on the problem frequency.
TX MODE: Select the mode for which to set TX power.
TX FREQ: Select the frequency.
TX POWER: Set the output level.
TX POWER ADJ: Set the TX power.
TX TONE: Output tone.
LOAD DEFAULT: Restore default TX power (frequency) settings.
For details of the settings on the [TX POWER (FREQ)] menu, see the service manual
of FS-1575/2575/5075.
TX PWR (USER CH)
* Shown for FS-5075 only
TX power on user channels can fluctuate according to antenna location. If this occurs,
adjust the TX power on user channels.
3-4
IC1
xx.xA
x.xA*
xx.xA
IC2
x.xA*
VC2
xx.xV
x.xV*
xx.xV
xx.xA
IC1
x.xA*
xx.xA
IC2
x.xA*
VC2
xx.xV
x.xV*
xx.xV
PA1 current
PA2 current
VC of PA2
PA1 current
PA2 current
VC of PA2