Table of Contents
Advertisement
Installing a 9.5 mm slim optical drive
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
If you are installing a slim optical drive in a bay covered by a bezel blank, remove the front bezel and
then remove the bezel blank. See
4.
Follow the instructions for removing the optical drive if one was installed. Refer to
slim optical drive on page
5.
Align the small pin on the release latch with the small hole on the side of the drive and press the latch
firmly onto the drive.
6.
Slide the optical drive through the front of the chassis (1) all the way into the bay so that the green latch
locks onto the chassis frame (2).
28
Chapter 4 Removal and replacement procedures – Microtower (MT) chassis
(Preparation for disassembly on page
(Access panel on page
15).
Front bezel on page 16
27.
14).
for more information.
Removing a 9.5 mm
Advertisement
Table of Contents
