Yamaha RX10H Service Manual page 673

SPEC
CABLE ROUTING
Route the fuel tank breather
hose behind the steering gate.
Wire harness
Bracket
When the gear position switch
lead is equipped with reverse,
route it to the reverse gear.
If it is not equipped with reverse,
insert it to the inner side.
Fuse box
Coolant reservoir tank
Clamp
Brake hose
Parking brake cable
After clamping, bend it 90°
downward.
Clamp
Clamp the hose at the white
paint position.
Point the clamp position to the
front outside.
Clamp the battery positive lead
and battery negative lead.
Latch
Engine oil tank hose
Point the clamp tightening direc-
tion to the downward.
Drain hose
Less than 30 mm (1.2 in).
Pass the coolant reservoir tank
breather hose through between
engine and heat exchanger.
Clamp the rear suspension sub-
lead. (RX10GTL)
To the tail/brake light.
Pass the wire harness and
unused lead for the electronic
rear suspension between the
ribs of side cover 2 and frame.
144