Yamaha RX10H Service Manual page 492

32 Route the starter cable above
the left handlebar switch lead.
33 Brake hose
34 Fuel sender lead coupler
35 Clamp the ignition coil lead un-
der the fuel hose.
36 Clamp the fuel hose.
37 Route the coolant hose be-
tween the upper vacuum hose
and lower vacuum hose.
38
Route the vacuum hose under
the coolant hose.
39
Route the vacuum hose over
the coolant hose.
40
Clamp the coolant hose and
vacuum hose.
41
Clamp the coolant hose and
vacuum hose 2.
42 Point the pawl of clip to the up-
ward.
43 Clamp the throttle position
switch lead.
44 Throttle position sensor lead
coupler. (under the vacuum
hose)
45 Drive guard bracket
46 Connect the battery negative
lead to the starter motor mount-
ing bolt.
47 Clamp the throttle position
switch lead and carburetor
switch lead.
48
Voltage regulator
49
Carburetor heater relay
50
Headlight relay
51
Main relay
52
Back buzzer (RX10RK, RX10
RSK, RXW10K, RXW10SK)
53
Flange nut
54
Hexagon bolt
55
Two pole coupler for A.C.mag-
neto.
56 Between two pole coupler for
A.C.magneto leaf and the
clamp is set to 20 mm (0.79 in)
or less.
CABLE ROUTING
75
SPEC