Yamaha RX10H Service Manual page 230

WATER PUMP
NOTE:
S Install the water pump seal 1 with the water
pump seal installers 4 5 .
S Before installing the water pump seal, apply
Yamaha bond No.1215 2 to the water pump
housing 3 .
Water pump seal installer:
90890-04078, YM-33221
40 and 50 mm Bearing driver:
90890-04058, YM-4058
Yamaha bond No.1215
90890-85505, ACC-11001-05-01
A Push down
4. Install:
S Rubber damper holder 1
S Rubber damper 2
NOTE:
Before installing the rubber damper, apply tap
water or coolant onto its outer surface.
5. Measure:
S impeller shaft tilt
Out of specification ! Repeat steps (4) and
(5).
CAUTION:
Make sure the rubber damper and rubber
damper holder are flush with the impeller.
Max. impeller shaft tilt:
0.15 mm (0.0059 in)
<Limit>: 0.072 mm (0.0028 in)
1 Straightedge
2 Impeller
6-11
COOL