Special Tools; For Tune Up - Yamaha RX10H Service Manual

SPECIAL TOOLS

SPECIAL TOOLS
Some special tools are necessary for a completely accurate tune-up
and assembly. Using the correct special tool will help prevent dam-
age that can be caused by the use of improper tools or improvised
techniques.
NOTE:
Be sure to use the correct part number when ordering the tool, since
the part number may differ according to country.

FOR TUNE UP

S Sheave gauge
P/N: YS-42421-1 (15 mm offset) (for U.S.A./Canada)
This gauge is used to measure the sheave distance and for offset ad-
justment.
S Dial gauge
P/N: YU-03097 (for U.S.A./Canada)
90890-03097 (for Europe)
This gauge is used for run out measurement.
S Fuel level gauge
P/N: YM-01312-A (for U.S.A./Canada)
90890-01312 (for Europe)
This gauge is used to measure the fuel level in the float chamber.
S Carburetor angle driver:
P/N: 90890-03173 (for Europe)
This tool is used to adjust the pilot screw when synchronizing the ca-
buretor.
S Angle gauge:
Use goods on the market.
This tool is used to tightening the torque.
1-4
GEN
INFO