Ice And Water - KitchenAid P9WB2L Use & Care Manual

Temperature is too cold in The refrigerator air vent(s) are blocked. If the air vent located in the top, left, rear corner of the
the refrigerator/crisper refrigerator compartment is blocked by items placed directly
in front of it, the refrigerator will get too cold. Move items
away from the air vent.
The controls are not set correctly for Adjust the controls a setting warmer. Check the temperature
the surrounding conditions, in 24 hours. See "Using the Controls."
The ice storage bin is not in the See "Ice Maker and Ice Storage Bin."
correct position.
Temperature is too cold in The control is not set correctly for the Adjust the temperature setting. See "Temperature Controlled
the pantry drawers items stored in drawer. Drawer" in the "Refrigerator Features" section.
There is interior moisture The room is humid A humid environment contributes to moisture buildup.
buildup
NOTE: Some moisture The door(s) are opened often or not Allows humid air to enter the refrigerator. Minimize door
closed completely, openings and close doors completely.
buildup is normal ...................................................................................................................................................................................................................................
The door is blocked open Move food packages away from door.
A bin or shelf is in the way Push bin or shelf back into the correct position.
Storing liquid in open containers This adds humidity to the refrigerator interior. Keep all
containers tightly covered.
There is frost/ice buildup in The drawer is opened often or left Minimize drawer openings and close drawer completely after
the freezer compartment open. use.
Poor door seal Ensure door seals are making full contact with the
refrigerator cabinet to allow for an adequate seal.
Temperature controls are not set See "Using the Controls" for recommended temperature
correctly settings.
and Water
The ice maker is not
producing ice or is not
producing enough ice
The refrigerator is not connected to a Connect refrigerator to water supply and turn water shutoff
water supply or the water supply valve fully open.
shutoff valve is not turned on.
There is a kink in the water source line. A kink in the line can reduce water flow. Straighten the water
source line.
The ice maker is not turned on. Make sure the ice maker is on. See "Ice Maker and
Ice Storage Bin."
The refrigerator has just been Wait 24 hours after ice maker installation for ice production
installed, to begin. Wait 3 days for full ice production.
The refrigerator door is not closed Close the door firmly. If it does not close completely, see
completely. "The doors will not close completely."
A large amount of ice was recently Allow sufficient time for ice maker to produce more ice. See
removed. "Ice Maker and Ice Storage Bin" for ice production rates.
An ice cube is jammed in the ice Remove ice from the ejector arm with a plastic utensil.
maker ejector arm.
A water filter is installed on the Remove the water filter and operate the ice maker. If ice
refrigerator, volume improves, then the filter may be clogged or
incorrectly installed. Replace filter or reinstall it correctly.
A reverse osmosis water filtration This can decrease water pressure. See "Water Supply
system is connected to your cold Requirements."
water supply.
34