Table of Contents
Advertisement
6
Configuring
the System
Configuring the System
Wiih the KTM-8000/386
board added to the
system, you have to reconfigure
the system
so that the system will recognize the new
board. You can use the Configuration
Dis-
kette created earlier to accomplish
this.
3.
Press
[ENTER]
to generate the next
screen display.
4.
At the message "Automaticaily
con-
figure the system? (Y/N)", press [VI.
1.
Insert the Configuration
Diskette in
5.
After the automatic
configuration
is
drive A.
done, remove the Configuration
Dis-
kette and press [ENTER] to reboot the
2.
Turn on the computer.
The screen
system. The screen will display the total
should display the size of base
memory as installed during the reboot
memory, followed
by the number 765.
process.
This indicates a new device has been in-
stalled on the system. The IBM logo will
appear after 5-10 seconds.
KTM-8000/386
Installation
Guide - REV D
Kingston Technology
Corporation
Advertisement
Table of Contents
