Installing Simm Modules - Kingston Technology KTM8000/386 Installation Manual

4
Installing SIMM Modules
Installing SIMM Modules
Use Kingston's 2MB SIMM modules (KTM-
20OO/M70) or equivalent to plug into the
KTM-8000/386 memory expansion board.
Use the following figures and procedure to
install SIMM memory modules onto the
KTM-8000/386 expansion memory board.
1.
SIMM modules must be installed con-
secutively in Pl, P2, P3, and then P4.
Install the first SIMM module in
memory bank 0 (Pl) shown in Figure
1.
The second SIMM module is installed
in memory bank 1 (P2). Up to four
SIMM modules can be installed,
where the last SIMM module occupies
bank 3 (P4).
2. Install each module by plugging it into
the appropriate SIMM socket. Notice
that the SIMM module plugs into the
socket at an angle (Figure 2).
Figure 2: Installing the SIMM Modules
3. Carefully push the SIMM module into
the SIMM socket until it is firmly
seated.
4. Push the SIMM module towards the
memory expansion board. Push
downwards on the SIMM module until
the flange shown in Figure 3 snaps
over the module.
Figure 3: Installing the SIMM Module
KTM-8000/386 Installation Guide - REV D Kingston Technology Corporation