Yamaha Clavinova CVP-405 Service Manual page 92

CVP-405/CVP-405PE/CVP-405PM
* Follow the display on the screen for this operation.
1
Press the [START/STOP] button and start the installations.
2
Then, the installation starts automatically.
3
It shows the following on LCD during installations.
Now installing. Please wait a moment ...
4
Finish the installations, then it shows the following message on LCD.
Success:
Updating has been completed.
Turn the power off.
5
Turn off the power supply of the instrument.
Please refer to the error message table (page 93) if it will show an error message on LCD.
3
Verify the version
1
Turn on the power supply of the instrument with pressing
the [DIRECT ACCESS] switch simultaneously.
2
Version display mode starts.
3
Check that the version of Main Program on LCD is in
agreement with the version of install data.
4
Check that all items are set to OK.
5
If it checks that it is satisfactory, turn off the power supply
of the instrument.
4
Complete installation
The program installation is completion above.
Please refer to the trouble shootings (page 93) if an error will occur during installations.
92
Failure:
Install error !
Please check installations data and try again.
The version display on LCD.
CVP-405 (Example)
Version Overview
Model Name
Main Boot
Sub Boot
Main Program
Sub Program
BitMap
LCD Patch
Contents1
Contents2
Font
Wnn
Wave1
MAC Address
Press [EXIT] to quit.
: CVP-405 (E)
: 1.00
: 1.03
: 1.00 OK
: 1.00 OK
: 1.00 OK
: 1.00 OK
: 1.01 OK
: 1.00 OK
: 1.00 OK
: 1.10 OK
: 1.00 OK
00:A0:DE:25:76:49