Key Cover Assembly; Installation Of Key Cover; Key Cover & Panel Assembly - Yamaha Clavinova CVP-405 Service Manual

Hide thumbs Also See for Clavinova CVP-405:
Table of Contents

Advertisement

CVP-405/CVP-405PE/CVP-405PM
10.

Key Cover Assembly

(Time required: About 5 minutes)
10-1. Remove the top board assembly. (See procedure 4)
10-2. Open the back key cover. (See procedure 5-2)
10-3. Remove the four (4) screws marked [3B]. (Fig. 17)
10-4. Using the tip end of the panel as the fulcrum, pull up
the key cover assembly to remove it. (Fig. 18)

Installation of Key Cover

Fit the sash of the key cover over the tip end of the
panel and install the key cover, using care for the
balance between right and left. When the key cover
is installed properly, lugs of the panel (CP holders) at
6 locations should fi t in the groove in the key cover.
If there is a lug (CP holder) that is not fitted in the
groove, push around it so that it will fi t in the groove.
(Fig. 18, Fig. 19)
[3B]:
Key Cover & Panel Assembly
<Side view / 側面 >
Panel assembly
(パネルAss' y)
(CP固定金具)
20
[3B]
Bind Head Tapping Screw-B (B タイト+ BIND) 3.0x10 MFZN2W3 (WE774200)
(回転蓋 Ass' y)
Key cover(回転蓋)
CP holder
10.
回転蓋
(所要時間:約 5 分)
10-1.
屋根 Ass' y を外します。 (4 項参照)
10-2. 回転蓋 (後)を開けます。 (5-2 項参照)
10-3. [3B] のネジ 4 本を外します。 (図 17)
10-4. パネルの先端を支点として回転蓋を引き上げて、回
転蓋を外します。 (図 18)
回転蓋の取り付け方法
回転蓋のサッシをパネルの先端に掛け、左右ずれないよう
に回転蓋を装着します。
正常に装着されるとパネルの突起 (CP 固定金具)6 箇所が
回転蓋のサッシの溝に嵌まります。
このパネルの突起 (CP 固定金具)部がサッシの溝に嵌まら
ないときは、CP 固定金具付近を押して、サッシの溝に嵌め込
みます。 (図 18、図 19)
Back key cover(回転蓋(後))
(Fig. 17)(図 17)
Panel assembly
Groove
(パネルAss' y)
(溝)
(Fig. 18)(図 18)
[3B]
Key cover
(回転蓋)
Sash
(サッシ)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Clavinova cvp-405peClavinova cvp-405pm

Table of Contents