How To Connect Video Components - McIntosh MX134 Owner's Manual

How to Connect Video Components

There are three types of Video Signals that can be con-
nected to and selected by the MX134; Composite, S-Video
and Component. The built-in Digital Video Processing Cir-
cuitry can Up-Convert the desired Composite Input to S-
Video; it will also Up-Convert the desired Composite or S-
Video Inputs to Component Video. Connect all of the avail-
able Source Component Video Outputs (Component, S-
Video and Composite), using the appropriate Video Cables
to the MX134. This will assure that video is available to
the Zone B and VCR Outputs.
1. Connect video cables from the MX134 DVD VIDEO
INPUTS to the McIntosh Video Outputs of the
MVP841 DVD Player.
2. Connect video cables from the MX134 SAT INPUTS
to the Video Outputs of a Satellite Receiver.
Monitor/TV
To AC Outlet
McIntosh MVP841 DVD Player
How to Connect Video Components
3. Connect video cables from the MX134 VCR1 INPUTS
to the VCR Video Outputs.
4. Connect video cables from the MX134 VCR1 OUT-
PUTS to the VCR Video Inputs.
5. Connect video cables from the MX134 CD1 INPUT to
the Video Outputs of the DVD-Audio/SACD Disk
Player.
6. Connect video cables from the MX134 COMPONENT
Video OUTPUTS to the Monitor/TV Component
Video Inputs.
Note: If the Monitor/TV does not have Component Video
Inputs, then connect the MX134 MON A S Video or
Composite Output(s) instead.
Note: If the MX134 A/V System Control Center
has the TM1 AM/FM Tuner Module
installed, proceed to page 54 for How to
Connect Antennas Information.
Satellite Receiver
VCR
OUT
IN
DVD Audio/SACD Player
15