Disassembling And Reassembling The Mighty Cooling Unit - Storz & Bickel GMBH MIGHTY Instructions For Use Manual

10. DISASSEMBLING, CLEANING AND ASSEMBLING
10.1. Disassembling and Reas-
sembling the MIGHTY Cooling
Unit
Turn the Cooling Unit with a 90° rota-
tion counterclockwise in order to re-
move it from the Vaporizer.
Pull out the Mouthpiece from the Cool-
ing Unit cap, rotate slightly back and
forth while doing this, and pull off the
Mouthpiece Seal Ring.
Pulling the Mouthpiece from the Cooling Unit
Cap
Open the Cap Lock by pulling it rear-
wards.
Opening the Cap Lock
Remove the Cap Lock from the cap by
pulling up at one side.
If the Cooling Unit must be im-
mersed into alcohol (ethanol)
the Cap Lock only has to be
removed from the Cooling Unit. Ex-
tended contact with alcohol can lead
to whitening of the Cap Lock Label or
disintegration of the glue.
Removal of the Cap Lock
Separate the Cooling Unit Cap from
the Cooling Unit Base by pulling off
the cap upwards.
24
10. DISASSEMBLING, CLEANING AND ASSEMBLING
Pull the Cooling Unit
Cap from the Cooling Unit Base
Remove the large and small Base
Seal Rings. Lever out the large Seal
Ring from the recess in the notch us-
ing the Filling Chamber Tool.
Removal of the large Base Seal Ring
Push the upper Screen downwards
out of the Filling Chamber Cap from
above by using the Filling Chamber
Tool supplied.
Pressing out the upper Screen
Reassemble in reverse order.
When assembling, make sure
that Seal Rings are properly
seated. The Mouthpiece Seal
Ring, especially, must sit completely
in the cap and be no longer visible.
The upper Screen must be inserted
carefully into the groove provided.
Disregarding this may allow plant
particles to enter the Cooling Unit, so
blocking this or be inhaled.
25