Dpd - HPE FlexFabric 7900 Series Security Command Reference

NAT traversal: Not detected
Table 33 Command output
Field
Connection ID
Outside VPN
Inside VPN
Profile
Transmitting entity
Local IP
Local ID type
Local ID
Remote IP
Remote ID type
Remote ID
Authentication-method
Authentication-algorithm
Encryption-algorithm
Life duration(sec)
Remaining key duration(sec)
Exchange-mode
Diffie-Hellman group
NAT traversal

dpd

Use dpd to enable the device to send DPD messages.
Use undo dpd to disable the IKE DPD function.
Syntax
dpd interval interval-seconds [ retry seconds ] { on-demand | periodic }
undo dpd interval
Default
IKE DPD is disabled.
Views
IKE profile view
Description
Identifier of the IKE SA.
VPN instance name of the MPLS L3VPN to which the receiving
interface belongs.
VPN instance name of the MPLS L3VPN to which the protected data
belongs.
Name of the matching IKE profile found in the IKE SA negotiation.
If no matching profile is found, this field is blank.
Role of the IKE negotiation entity: Initiator or Responder.
IP address of the local gateway.
Identifier type of the local gateway.
Identifier of the local gateway.
IP address of the remote gateway.
Identifier type of the remote gateway.
Identifier of the remote security gateway.
Authentication method used by the IKE proposal.
Authentication algorithm used by the IKE proposal:
•
MD5—HMAC-MD5 algorithm.
•
SHA1—HMAC-SHA1 algorithm.
Encryption algorithm used by the IKE proposal.
Lifetime of the IKE SA in seconds.
Remaining lifetime of the IKE SA in seconds.
IKE negotiation mode in phase 1: main mode or aggressive mode.
DH group used for key negotiation in IKE phase 1.
Whether NAT traversal is detected.
221