HPE FlexFabric 7900 Series Security Command Reference page 184

mdc-admin
mdc-operator
Parameters
policy: Displays information about IPv4 IPsec policies.
policy-name: Specifies an IPsec policy by its name, a case-insensitive string of 1 to 63 characters.
seq-number: Specifies an IPsec policy entry by its sequence number in the range of 1 to 65535.
Usage guidelines
•
If you do not specify any parameters, this command displays information about all IPsec
policies.
•
If you specify an IPsec policy name and a sequence number, this command displays
information about the specified IPsec policy entry. If you specify an IPsec policy name without
any sequence number, this command displays information about all IPsec policy entries with
the specified name.
Examples
# Display information about all IPv4 IPsec policies.
<Sysname> display ipsec policy
-------------------------------------------
IPsec Policy: mypolicy
Interface: Vlan-interface 1
-------------------------------------------
-----------------------------
Sequence number: 10
Mode: manual
-----------------------------
Security data flow: 3101
Remote address: 192.168.0.64
Transform set: tran1
Inbound AH setting:
AH SPI:
AH string-key:
AH authentication hex key:
Inbound ESP setting:
ESP SPI: 54321 (0x0000d431)
ESP string-key: ******
ESP encryption hex key:
ESP authentication hex key:
Outbound AH setting:
AH SPI:
AH string-key:
AH authentication hex key:
Outbound ESP setting:
ESP SPI: 12345 (0x00003039)
176