State; Usage - HPE FlexFabric 7900 Series Security Command Reference

Make sure there is a route between the source IP address and the CA server.
You can specify only one source IP address in a PKI domain. If you configure this command multiple
times, the most recent configuration takes effect.
Examples
# Specify 111.1.1.8 as the source IP address for PKI protocol packets.
<Sysname> system-view
[Sysname] pki domain aaa
[Sysname-pki-domain-aaa] source ip 111.1.1.8
# Specify the IP address of VLAN-interface 1 as the source IPv4 address of PKI protocol packets.
<Sysname> system-view
[Sysname] pki domain aaa
[Sysname-pki-domain-aaa] source ip interface vlan-interface 1

state

Use state to set the state or province name for a PKI entity.
Use undo state to remove the configuration.
Syntax
state state-name
undo state
Default
No state name or province name is set for a PKI entity.
Views
PKI entity view
Predefined user roles
network-admin
mdc-admin
Parameters
state-name: Specifies a state or province by its name, a case-sensitive string of 1 to 63 characters.
No comma can be included.
Examples
# Specify countryA as the state name of the PKI entity en.
<Sysname> system-view
[Sysname] pki entity en
[Sysname-pki-entity-en] state countryA

usage

Use usage to specify the extensions for certificates.
Use undo usage to remove certificate extensions.
Syntax
usage { ike | ssl-client | ssl-server } *
undo usage [ ike | ssl-client | ssl-server ] *
161