Enabling Logging Of Ipsec Packets; Configuring The Df Bit Of Ipsec Packets - HPE FlexFabric 7900 Series Security Configuration Manual

Step

Enabling logging of IPsec packets

Perform this task to enable the logging of IPsec packets that are discarded because of reasons such
as IPsec SA lookup failure, AH-ESP authentication failure, and ESP encryption failure. The log
information includes the source and destination IP addresses, the SPI value, and the sequence
number of a discarded IPsec packet, and the reason for the failure.
To enable the logging of IPsec packets:
Step
1. Enter system view.
2. Enable the logging of IPsec
packets.

Configuring the DF bit of IPsec packets

Perform this task to configure the Don't Fragment (DF) bit in the new IP header of IPsec packets in
one of the following ways:
•
clear—Clears the DF bit in the new header.
•
set—Sets the DF bit in the new header.
•
copy—Copies the DF bit in the original IP header to the new IP header.
You can configure the DF bit in system view and interface view. The interface-view DF bit setting
takes precedence over the system-view DF bit setting. If the interface-view DF bit setting is not
configured, the interface uses the system-view DF bit setting.
Follow these guidelines when you configure the DF bit:
•
The DF bit setting takes effect only in tunnel mode, and it changes the DF bit in the new IP
header rather than the original IP header.
•
Configure the same DF bit setting on the interfaces where the same IPsec policy bound to a
source interface has been applied.
To configure the DF bit of IPsec packets on an interface:
Step
1. Enter system view.
2. Enter interface view.
3. Configure the DF bit of
IPsec packets on the
interface.
To configure the DF bit of IPsec packets globally:
Command
Command
system-view
ipsec logging packet enable
Command
system-view
interface interface-type
interface-number
ipsec df-bit { clear | copy | set }
117
Remarks
disabled.
Remarks
N/A
By default, the logging of IPsec
packets is disabled.
Remarks
N/A
N/A
By default, the interface uses the
global DF bit setting.