Follett 7CI100A Installation, Operation And Service Manual page 28

Service
(continued)
7 .
Install compression nozzle:
§ Remove and inspect compression nozzle O-ring seal .
Replace if damaged in any way .
§ Clean O-ring groove . Lubricate O-ring with Petro-gel and
reinstall .
§ Install compression nozzle (Fig . 27 .1) .
§ Install compression nozzle retainer (Fig . 27 .2) .
§ Install M6 socket head allen screw (Fig . 27 .3) .
8 . Install transport tube (Fig . 28 .1) .
9 . Tighten hose clamp (Fig . 28 .2) .
10 . Install gear motor:
§ Install main housing insulation (Fig . 29 .1) .
§ Slide gear motor onto auger shaft (Fig . 29 .2) .
§ Install two M6x90 allen screws (Fig . 29 .3) .
28 Sparkling Ice and Water Dispenser 7CI100A/7FS100A, 15CI100A/15FS100A
–––––––––––––––––––––––––––––––––––––––––––––––––––
Fig . 27
3
2
Fig . 28
1
Fig . 29
3
2
3
1
2
1