Follett 7CI100A Installation, Operation And Service Manual page 11

4 . Position chiller/carbonator in cabinet (allow for required clearances, 4" on sides and back) and mark for
toe-kick recess cutout (Fig . 3) .
5 . Use appropriate tool to make toe-kick recess cutout .
6 . Rough-in the electrical service and water line(s) .
§ Electrical: 115V, single phase, 15A receptacle required . The dispenser has an integral 8 ft . (2 .4 m) cord and
plug . The chiller/carbonator connects to the dispenser via a supplied 6 ft . power cord .
§ Water: supply line (with shut-off valve) connects to the dispenser's 1/4" NPT male inlet . A tee fitting can be
employed to supply both the dispenser and chiller/carbonator from a single shut-off valve . Alternatively, a
second supply line (with shut-off valve) can be installed within the cabinet for the chiller/carbonator's 1/4"
push-to-connect inlet .
NOTICE!
If installing optional Drip Tray Drain Kit or Leg Accessory, complete those steps before proceeding.
Refer to instructions included with the Drip Tray Drain Kit, or see
instructions.
Fig . 3
7 . Place chiller/carbonator unit on floor in front of dispenser .
8 . Follow the Final Connections instructions for countertop models that follows .
CUTOUT FOR DISPENSER
COUNTERTOP
VENTILATION CUTOUT TO BE
PLACED OVER KICK RECESS AND
ALIGNED WITH VENT SHROUD
Sparkling Ice and Water Dispenser 7CI100A/7FS100A, 15CI100A/15FS100A
page 12 for Leg Accessory
1.47"
5.13"
11