Omron G9SP Series Manual page 27

G9SP-series Controller Settings
Make the settings for TCP/IP in the system settings of the G9SP Configurator.
These settings are set in the G9SP-series Controller and Ethernet Option Board when the
configuration data is downloaded.
Parameter
IP address of Ethernet Option Board.
IP address
Default value: 192.168.250.1
Subnet mask of Ethernet Option Board.
Subnet mask
Default value: 255.255.255.0
Set the IP address of the default gateway.
Default gateway
Default value: 0.0.0.0 (IP routing not supported)
Set the FINS node address of the Ethernet Option Board. If
FINS node address
automatic setting is specified, a value that matches the
rightmost byte of the IP address is stored.
Default value: Automatic (matching the rightmost byte of the
IP address)
Setting range: 1 to 254
Specify the UDP port number that is specified in the FINS
FINS/UDP port
communications service. The UDP port number is a number
used by UDP to identify the application layer (here, the FINS
communications service).
Default value: 0 (9600)
Setting range: 0 to 65535. When set to 0, the FINS/UDP port
number is 9600.
Set the table that defines correspondence between the FINS
IP address table
node address and IP address at the Standard PLC.
Set the IP address table when IP routing is used.
2 - 3 Ethernet Communications
Description Set value for this
example
192.168.250.11
No change is
required.
No change is
required.
No change is
required.
No change is
required.
No change is
required.
2
2-17