Beeper
The beeper is for quick continuity tests without the need to
watch the display. If on, the beeper sounds as long as a circuit
is complete.
Auto Dim
Push to brighten or dim the backlight. If on, the Auto Dim
feature automatically dims the backlight after 2 minutes of no
use.
To set:
1.
Push to open the Setup Menu.
2.
Use to highlight the feature.
3.
Push
(Select) to open the submenu.
4.
Use to set as OFF or ON.
5.
Push
(Done) to save the selection and exit the
submenu.
6.
Push (Exit) to close the Setup Menu.
True-rms Thermal Multimeter
Auto Off
To save battery power, you can set the Multimeter to
automatically turn off after 20 minutes of no use.
To set:
1.
Push to open the Setup Menu.
2.
Use to highlight the feature.
3.
Push
(Select) to open the submenu.
4.
Use to set as OFF or ON.
5.
Push
(Done) to save the selection and exit the
submenu.
Auto Off is always disabled when MIN MAX AVG
recording or a Fluke Connect session is in progress.
6.
Push (Exit) to close the Setup Menu.
Temperature Units
Select temperature unit as degrees C or degrees F.
Before You Start
11