Disabling The Beeper - Fluke 12B/18 Instruction Sheet

riešenia na presné meranie
Continuity Capture™
(Open/Short Capture on Model 18)
To set up the meter to capture intermittent shorts and opens, turn the
switch to J, connect the leads to the circuit; then press
M
M
Captures transitions longer than 250 µS.
Transitions after the first transition cause the meter to beep, but the
display does not change.
To reset the display to the current condition, press
M
To exit, press

Disabling the Beeper

To disable the beeper for all modes, hold down
turning the meter on.
for 2 seconds, or change the measurement mode.
http://www.elso.sk
M
.
M
M
M
.
r
for 2 seconds while
ag12i.eps