Profile Pushbutton - ATEN VM3404H User Manual

Profile Pushbutton

The PROFILE pushbutton lets users conveniently switch between connection
profiles that have been saved or added to the Profile List (see Profile List,
page 41).
When a Profile is in use, its profile number (P1–P18) is shown on the lower
right corner of the LCD display.
INPUT
OUTPUT
The Profile pushbutton functions as follows:
 Press the Profile pushbutton for 1–2 seconds to cycle between profiles
stored in the GUI's Profile List (from 1 up to 18) or (from 1 up to 8)
depending on how many are added to the list.
 Alternatively, after pressing the Profile pushbutton (lights), use the Input/
Output pushbuttons to switch to a specific profile (P1 to P18) or (P1 to
P8). Note that:
 Input ports 1–9 or 1-4 correspond to Profile P1 to P9 or P1 to P4
 Output ports 1–9 or 1-4 correspond to Profile P10 to P18 or P5 to P8
(where Output Port 1=Profile 9, Output Port 2=Profile 10... Output
Port 9=Profile 18)
The selected pushbutton lights steady, and the VM3404H / VM3909H
immediately applies the port connections configured in the selected
profile.
 When the Profile pushbutton is pressed for 3 seconds or more, the LCD
directs to the Save to a Profile page (see Save to a Profile, page 35)
 Press the Cancel pushbutton to exit
Note: If there are no profiles configured on the VM3404H / VM3909H device,
an error message "No Profile List defined. Profile List can be edited via
the Web GUI" is displayed when the Profile pushbutton is pressed.
A Profile's port connections can be edited using the front panel pushbuttons
(see Port Switching, page 19) or from the Connections page of the Browser
GUI (see Connection Profiles, page 48). Additionally, the Profile List can be
configured via the Profile page of the Browser GUI (see Profile List, page 41).
1 2 3 4
1 2 3 4
P1
Chapter 3. Front Panel Configuration
37