Removing Tooling - Grizzly G0768 Owner's Manual

Removing Tooling

Tools Needed
Wrench 8mm ..................................................... 1
Wrench 17mm.................................................... 1
Wrench 25mm ................................................... 1
Brass Hammer .................................................. 1
To remove tooling:
1. DISCONNECT MACHINE FROM POWER!
2. Remove drawbar cap.
3. Loosen drawbar lock nut (see Figure 113) on
previous page.
4. Unthread drawbar from tooling one full rota-
tion.
Note: Do not fully unthread tooling from
drawbar or the drawbar and tool threads
could be damaged in the next step.
-66-
5. Tap top of drawbar with hammer to unseat
taper (see Figure 114).
Qty
Figure 114. Tapping drawbar to unseat tool
6.
Hold onto tooling with one hand and fully
unthread drawbar.
Model G0768/G0769 (Mfd. Since 8/15)
taper.