Installing/Removing Tooling; Installing Tooling - Grizzly G0754 Owner's Manual

Installing/Removing
Tooling
the Model g0754 includes the following spindle
tools (see Figure 20):
A. b16 Drill chuck w/R-8 Arbor. Joined with
the drill chuck.
b. R-8–MT#3 Spindle Sleeve. used for Mt#3
tools and will accommodate tools with a tang.
it also has a drift key slot for tool removal.
c. MT#3–MT#2 Spindle Sleeve. used with the
r-8–Mt#3 spindle sleeve for Mt#2 tools and
has a drift key slot for tool removal.
Alignment slot
A
Figure 20. tool and arbors included with
Model g0754.
cutting tools are sharp and
can easily cause laceration
injuries. Always protect
your hands with leather
gloves or shop rags when
handling cutting tools.
Model G0754 (Mfg. Since 1/13)
drift Key slot
B
C

Installing Tooling

1.
disConneCt MAChine FroM poWer!
2.
remove the drawbar cap as shown in
Figure 21.
drawbar
drawbar Cap
Adjustment
nut
Figure 21. drawbar components.
3. Align the tool alignment slot (see Figure 21)
with the pin inside the spindle, then insert
your tooling into the spindle until it contacts
the drawbar.
Note: The height of the drawbar inside the
spindle can be changed by rotating the
adjustment nut (see Figure 21).
4.
Working from the top, thread the drawbar by
hand into the tool until it is snug, then use a
19mm wrench to tighten it.
Note: Do not overtighten the drawbar.
Overtightening makes tool removal difficult
and will damage the arbor and threads.
5. re-install the drawbar cap.
-23-