Solid-State Drives (M.2) - HP ZBook 17 G4 Mobile Workstation Maintenance And Service Manual

Solid-state drives (M.2)

Description
256 GB, Turbo Drive, G2, MLC
512 GB, M2 SATA-3, FIPS, TLC
256 GB, SATA-3 self-encrypting drive (SED), Opal 2, TLC
256 GB, Turbo Drive, G2, TLC
512 GB, Turbo Drive, G2, MLC
512 GB, Turbo Drive, G2, self-encrypting drive (SED), Opal 2, TLC
1 TB, Turbo Drive, G2, MLC
256 GB, SATA, TLC
1 TB, SATA-3, TLC
Before removing the SSD, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Service door (see
b. Battery (see
c. Base enclosure (see
d. Hard drive(s) and internal frame (see
Remove the SSD:
NOTE: The secondary SSD is only available if a primary SSD is installed.
1. Remove the Phillips screw (1) that secures the solid-state drive to the system board.
2. Remove the SSD (2) by pulling the drive away from the slot at an angle.
38 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
Service door on page
Battery on page 31).
Base enclosure on page
Hard drive(s) and internal frame on page
30).
33).
Spare part number
921331-001
921332-001
921333-001
921334-001
921335-001
921336-001
921337-001
921338-001
926788-001
33).