External Calibration/Adjustment - Sartorius LMA200PM Operating Instructions Manual

Example: Calibration and external adjustment of the weighing module
Prerequisite: Login with user privileges (with the default settings, administrator rights are required; see table on page 15).
Step
1. Switch on the LMA200PM
2. Login as Administrator
3. Activate external adjustment
4. Make sure there is no load on the
weighing module
5. Tare the weighing module
6. Calibrate the weighing module
7. Position the calibration weight
8. End calibration/adjustment
Key (or instruction)
Press the power switch on the right-hand
side of the analyzer
Tap the Login button
Tap the display line showing
"Administrator" privileges
Tap the line showing[Name]: PIN
Enter your PIN and confirm by pressing
Tap the Setup button
Tap the Calibration line
Tap the Cal./adj. weighing module line
Tap the External adjustment line
Remove any pad or sample from the sample
retainer
Tap the Tare button
Tap the Start button
Place the 50-g calibration weight on the
sample retainer
Remove the calibration weight
Close the cover
Press the key
Display/output
Prompt line (green background):
Tare or press start
Touchscreen keys:
Start
Status line (yellow background):
Taring the weighing module...
The status line briefly shows
the following (yellow background):
Initialing...
Afterwards the prompt line (green
background) shows:
Add weight
The info line shows:
Weight is in tolerance
Status line (yellow background):
Adjustment in progress...
At the conclusion of adjustment:
Message window Adjusted
The calibration record is printed:
–––––––––––––––––––––––––––––––
28.11.2007 17:41:46
Sartorius Microwave
Moisture Analyzer
LMA200PM-000EU Rel. 01.00.00
Serial no. 12345678
–––––––––––––––––––––––––––––––
External adjustment
W-ID
Nom. + 50.000 g
Diff. + 0.002 g
External adjustment
Diff. + 0.000 g
Completed
–––––––––––––––––––––––––––––––––
Signature
Tare
27