Specifications
Specifications
Measurement method
Microwave generator
Power output
Measurement range
Accuracy
Response time
Display of results
Weighing capacity
Resolution|reading accuracy
of the weighing system
Reading accuracy of the measurement results
Display module
Control elements
Program memory
Data storage
Built-in printer
Data interfaces
Power source
Fuse
Ambient conditions
Altitude
Operating temperature range
Allowable storage temperature range
Humidity
Dimensions (H + W + D)
Weight
Pollution degree 2
Limitation of emissions
Immunity to interference
Electrical safety
Accessories/Options
Product
80 glass fiber pads
500 disposable pipettes
Printer paper (five 20-m rolls)
36
Sample heated by microwave radiation; moisture content calculated from loss on drying
1000 W
2% to 100%, configurable in 1%-steps
8% to 100%
From 1 g initial sample weight +/– 0.05%
Approximately 40 to 120 seconds (depends on sample and moisture content)
% moisture content with calculation options; ppm moisture content,
% volatile components, %, ppm solids, g solids, mg solids, % ratio
70 g
0.1 mg
0.001%
4 VGA
Touchscreen, 5 function keys
320 drying programs with alphanumeric designation
The 500 most recent results, with statistical evaluation, stored in battery-backed memory
Thermal printer, 40 characters per line
1 serial RS-232 interface, 1 Ethernet port
230 V, 50 Hz, 1200 VA (LMA200PM-000EU)
115 V, 60 Hz, 1200 VA (LMA200PM-000US)
2 + 10 A/T (5 + 20 mm)
Indoor use only
up to 2000 m
5°C to 40°C (41°F to 104°F)
–10°C to +60°C (14°F to 140°F)
Maximum relative humidity: 80% for temperatures up to 31°C,
linear decrease to 50% relative humidity at +40°C
304 + 510 + 535 mm (12 + 20 + 21 in.)
Approximately 22 kg (48.4 lbs)
Normally only nonconductive pollution or temporary conductivity caused by condensation.
In accordance with EN 61326-1 (IEC 61326-1):
Group 1, Class B, suitable for use in domestic establishments and establishments
directly connected to a low-voltage power-supply network that supplies buildings used
for domestic purposes.
In accordance with EN 61326-1, (IEC-1 ):
Immunity test requirements for equipment intended for use in industrial locations (Table 2)
In accordance with EN 61010-1 (IEC 61010-1)
Order No .
6906940
YAT01MA
69MA30100