Connector Definitions; Power Connectors; Control Panel Connector - Supero 1028GQ-TR User Manual

S S
UPER ERVER 1028GQ-TR(T) User's Manual
5-7

Connector Definitions

Power Connectors

Two 50-pin proprietary power connectors (JPW1/JPW2) are used to provide main
power to your system. Four 8-pin power connectors, located at JPW3/JPW4/JPW5/
JPW6, provide power to PCI-E expansion cards. In addition, two 4-pin power con-
nectors (HDD_PWR1/HDD_PWR2) are used for onboard HDDs, while another 4-pin
power connector (FAN_PWR1) powers the fan board AOM-QG-FAN.
Caution: To provide adequate power to your system and to avoid damaging
the power supply or the motherboard, be sure to connect all power connectors
mentioned above to the power supply when using the devices mentioned. Failure
in doing so may void the manufacturer warranty on your power supply and
motherboard..
12V 8-pin Power
Connector Pin
Definitions
Pins Definition
1 through 3 +12V
4 through 8 Ground
(Required)

Control Panel Connector

The connector for the control panel on the front of the chassis is JF1.
Blue: OH/Fan Fail/Power Fail/UID LED
Figure 5-5. Front Control Panel Header Pins (JF1)
HDD_PWR1/HDD_
PWR2
Pin Definitions
Pins Definition
1-2 Ground
3 +5V
4 +12V
(Required)
20 19
Ground
x (key)
Power LED
HDD LED
NIC1 Link LED
NIC2 Link LED
Power Fail LED
Ground
Ground
2 1
5-14
NMI
x (key)
3.3V
UID Switch/Vcc
NIC1 Active LED
NIC2 Active LED
Red: (Blue LED Cathode)
3.3V
Reset Button
Power Button
FAN_PWR1
Pin Definitions
Pins Definition
1-2 Ground
3-4 +12V
(Required)