6-8
Power Supply
The 1028GQ-TR(T) has a 2000 watt redundant hot-plug power supply consisting of
two power modules. Each power supply module has an auto-switching capability,
which enables it to automatically sense and operate at a 100V - 240V input voltage.
Replacing a Power Supply Module
If either of the two power supply modules fail, the other module will take the full load
and allow the system to continue operation without interruption. The Power Fail LED
will illuminate and remain on until the failed unit has been replaced. Replacement
units can be ordered directly from Supermicro. Replace the failed hot-swap unit
with another identical power supply unit. The power supply modules can replaced
without powering down the system.
Replacing the Power Supply
1. Unplug the AC power cord from the failed power supply module.
2. Depress the release button on the power supply module.
3. Use the handle to pull the module straight out of the chassis.
4. Push the new power supply unit into the power bay until it clicks.
5. Plug the AC power cord back into the unit and power up the server.
Figure 6-11. Removing/Replacing the Power Supply
Chapter 6: Advanced Chassis Setup
6-15