Sharp FO-CC500 Service Manual page 8

FO-CC500A
FO-K01A
6
Insert the film into the print compartment.
Fit ends of rolls
onto hubs
Thick roll
to rear
7
Rotate the front gear as shown until the film is taut.
8
Close the operation panel (press down on both sides to make sure it
cliks into place).
3. Assembly and connections
1
Connect the handset as shown and place it on the handset rest.
♦ The ends of the handset cord are identical, so they will go into
either jack.
• Make sure the handset cord
goes into the socket
marked with a handset
symbol on the side of the
machine!
• Use the handset to make
ordinary phone calls, or to
transmit and receive faxes
manually.
2
Plug the power cord into a 230 - 240 V, 50 Hz, grounded AC (3-
prong) outlet.
• When disconnecting the fax, unplug the telephone line cord be-
fore unplugging the power cord.
• Caution:
The power outlet must be installed near the equipment and must
be easily accessible.
• The machine does not have a power on/off switch, so the power
is turned on and off by simply plugging in or unplugging the power
cord.
3
Insert one end of the telephone line cord into the adaptor. Insert the
other end of the line cord into the socket on the back of the machine
marked TEL. LINE. Plug the adaptor into the telephone socket on
the wall.
For Australia
For New Zealand
Setting the dial mode:
The fax machine is set for tone dialing. If you are on a pulse dial line, you
must set the fax machine for pulse dialing. Press the panel keys as
follows:
FUNCTION
1. Press once and
2. Press once and
3. Press once.
4. Select the dial mode:
TONE: PULSE:
1
STOP
5. Press to exit.
Note: For all units installed in New Zealand, select "1" for tone dialing.
The pulse setting "2" will not operate correctly and must not be used.
Note: If your area experiences a high incidence of lightning or power
surges, we recommend that you install surge protectors for the power
and telephone lines. Surge protectors can be purchased at most tel-
ephone specialty stores.
Moving your fax and reconnecting
Should be necessary to move your fax to a new location, first disconnect
the telephone line cord before disconnecting the power lead. When re-
connecting, it is necessary to connect the power lead before connecting
the telephone line cord.
About condensation
If the machine is moved from a cold to a warm place, it is possible that
condensation may from on the scanning glass, preventing proper scan-
ning of documents for transmission. To remove the condensation, turn
on the power and wait approximately two hours before using the ma-
chine.
1 – 6
Display:
once. OPTION SETTING
twice.
DIAL MODE
1=TONE, 2=PULSE
The display briefly shows
your selection, then:
2
PSEUDO RING