MODEL FO-K01 Charge the battery for about 10 hours before initial use. Introduction Connecting the Cordless Handset Charger Installing and Charging the Battery Registering the Cordless Handset Enterring a Name for the Cordless Handset Maintenance...
Introduction To use the FO-K01 cordless Thank you for handset, you must have a purchasing a FO-K01 SHARP FO-CC500 fax cordless handset. machine. Accessories Operation Battery Battery AC adapter Cordless manual cover pack handset charger Specifications Frequency 2.4 GHz (2.405 to 2.475 GHz)
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units.
Connecting the Cordless Handset Charger Connect the AC adapter to the Place the cord cordless handset charger. in the holders. Plug the AC adapter into a standard 220 - 240 V AC outlet. Important: Never cover the charger and AC adapter with a blanket, cloth, or other material.
Place the cordless handset in the charger with the dial pad facing forward. • Important! The dial pad must face forward, or the battery will not charge. • While charging the first time, the display may show PLEASE REGISTER. Be sure to let the battery charge for 10 Charge the battery hours, and then register the cordless...
Registering the Cordless Handset After the initial charging, To use the cordless the cordless handset handset, you must display shows: first register it with the fax machine. PLEASE REGISTER Cordless handset display: On the cordless handset, hold down MODE SELECT INTER 1: HS ENTRY until the display at right appears.
Note: If you take no action for one minute during the registration procedure, the procedure will be canceled. In this case, start from Step 1 again. The fax machine is identified by the number “0”, and the cordless handset that was included with the fax is identified by the number “1”.
Enter the name by pressing number keys for each letter as shown in the chart below. Up to 10 characters can be entered. Example: BILL = 22 444 555 SPACE = ♦ To enter two letters in succession that require the same key, press after entering the first letter.
If you find that LOW BATTERY appears in the cordless handset display soon after the battery is charged, replace it with the following battery: Replacement battery: Use only a Sharp UX-BA01 battery (3.6 V Ni-MH battery, capacity: 850 mAh) Caution: There is a danger of explosion if the battery is incorrectly replaced.
Deleting (changing) the cordless handset name Follow the steps below if you need to delete the cordless handset name. If you wish to change the name, delete it and then enter a new name. Fax machine display: FUNCTION Press once and 3 times on the fax machine.
Deleting a cordless handset If you wish to stop using a cordless handset, follow these steps to delete it (cancel the registration in the fax machine). Cordless handset display: On the cordless handset, hold down MODE SELECT INTER until the display at right appears. 1: HS ENTRY 2: HS DELETE Example: Cordless handset 2...