Hirschmann RS20 Programming Manual page 39

Ring Redundancy
fast-hiper-ring current-id
mode ring-manager
Mode of Switch set to Ring Manager
fast-hiper-ring current-id
nodes 3
Number of nodes set to 3
fast-hiper-ring current-id
operation enable
Operation set to Enabled
exit
show fast-hiper-ring
Ring ID: 1
(Default Fast HIPER-Ring ID)
Mode of Switch (administrative setting). Ring Manager
Mode of Switch (real operating state)... Ring Manager
Ring Name................................<empty>
Number of nodes in the ring............. 3
Port Number, Primary.................... 1/1, State: Not Connected
Port Number, Secondary.................. 1/2, State: Not Connected
VLAN ID................................. 0 (No VLAN)
Operation............................... Enabled
General Operating States:
FHR Setup Info (Config. Failure)........ Ring Port Link Error
Manager-related Operating States:
Ring State.............................. Open
Redundancy Guaranteed................... No
Round Trip Delay........................ 0
Note: Deactivate the Spanning Tree protocol for the ports connected to the
redundant ring, because the Spanning Tree and the Ring Redundancy work
with different reaction times (Redundancy:Rapid Spanning
Tree:Port).
Now you connect the line to the ring. To do this, you connect the two
devices to the ends of the line using their ring ports.
Redundanz L2P
Release 5.0 04/09
3.3 Example of Fast HIPER-Ring
Define this device as the ring manager.
Define the number of devices in the Fast HIPER-
Ring as 3.
Activate the Fast HIPER-Ring.
Switch to the Configuration mode.
Show the current parameters of the Fast HIPER-
Ring.
39