roco Z21 WLANmaus User Manual page 63

3.2.4 The WLANmaus has "CHILD LOCK" which can be set tomultiple levels and can be activated
after calling up the menu item using the arrow keys.
To block an area, you will need to enter a code which is comprised of 4 numbers (no letters!).
The password is then always requested when you wish to call up a protected area of the
WLANmaus.
Factory setting: OFF
▪
"DISABLE MENu": The three main menus cannot be called up;
▪ "DISABLE PRG-MENu": The quick-programming mode is also blocked;
▪ "DISABLE LIB-PRG-MENu": All changes to the locomotive library are also prevented in ad
dition to both items mentioned above.
▪ JEach input has to be confirmed by pressing the OK-key.
3.3 "RESET"
The WLANmaus is a particularly user-friendly digital controller and can be reset to the factory set-
tings, not just completely but also partially.
3.3.1 "CANCEL" can be regarded as the emergency exit from this menu item.
3.3.2 When the "SETTINGS" are reset, all entries in the "Settings" menu are reset to factory set-
tings. The locomotive library remains intact. If calibration has been performed (see 3.3.7), it
will have to be repeated after the reset.
3.3.3 Select this sub-item if you wish to delete the "LOCO LIBRARy."
3.3.4 you can use "FACTORy RESET" to reset your WLANmaus completely to the original status.
Any entries made are deleted.
With the items listed above, all you have to do is press the OK-key. you are then
automatically returned to the "RESET" menu item.
3.3.5 „you will not normally have to calibrate the WLANmaus as this is performed on delivery.
However, in the event of extreme temperature variations, the controller may need to be re-
adjusted, e.g. if a locomotive travels in the zero position. To do so, use the "CALIBRATION"
menu and proceed as follows:
▪ The first screen you see is the "START?" screen. To confirm, press the OK-key.
"LEFT" appears on the display screen.
▪ Turn the controller to the left as far as it will go. To confirm, press the OK-key.
"MIDDLE" appears on the display screen.
▪
Turn the controller to the middle (zero position) and confirm by pressing the OK-key.
"RIGHT" appears on the display screen.
▪ Turn the controller to the right as far as it will go. Once you have confirmed by pressing the
OK-key, you return to the start level "RESET".
If the WLANmaus no longer responds to keyboard commands, use the following key combination to
reset the unit to the factory setting:
Press -key and MENu-key simultaneously and press
displayed. Confirm the reset with OK-key and the WLANmaus is reset and restarted.
8010813920.indd 63
OK-key briefly. The text "RESET ALL?" is
Menus
63
20.01.2017 10:48:54