Samsung VP-D361i Service Manual page 28

Alignment and Adjustments
3) Rise Time Check
ΠPlayback the alignment tape.
´ Set to playback mode, and confirm that the waveform of PB RF signal rises flat within 3 seconds.
Also confirm that the tape is not twisted or curled around the Pinch Roller. (Fig. 3-23)
ˇ Run the tape in CUE/REV and FF/REW modes, then playback.
Confirm the waveform of PB RF signal rises flat within 3 seconds. Also confirm that the tape is not twisted or
curled around the Pinch Roller.
¨ Repeat steps 2. and 3.
4) Tape Path Check
ΠIn CUE and REV modes, check that the tape is not curled around the P3, P6 upper flange and P8
upper/Lower flanges.
MOTOR CAPSTAN
P8
P1 P2
3-16
P3
P6
Fig. 3-24
P3 P4 P6 P7
Fig. 3-25
P8
P9
Samsung Electronics