Camera Adjustment - Samsung VP-D361i Service Manual

3-2 Camera Adjustment

Note : How to adjust the camera system.
1) EEPROM stores confirmed adjustment value of each adjustment step.
2) DSP (Digital Signal Process : ICM01-Main PCB) digitalizes the camera signal.
3) When replacing the Main PCB or ICM15(EEPROM) data must be readjusted.
After changing LCD PCB and CVF PCB- always readjust the data for each part.
Once the adjusted valuse for each section has been confirmed the data must then be
stored into the EEPROM.
4) Adjust the following items after changing LENS Ass'y.
ΠLens Zoom Track
´ Auto HALL
ˇ Auto IRIS
ˇ Auto White Balance(indoor)
ˇ Auto White Balance(outdoor)
5) Adjust the following items after changing EEPROM and Camera Main PCB.
ΠLens Zoom Track
´ Zoom VR Center
ˇ Auto HALL
¨ Auto IRIS
ˆ Auto White Balance (indoor)
Ø Auto White Balance (outdoor)
3-2-1 Adjustment Preparation
1) Before you start
ΠUse the buttons on the CAMCORDER when adjusting Camera.
´ When changing the adjustment item, please press the "EASY-Q" or "DISPLAY" buttons on the Set.
ˇ You can chage the adjustment value to press macro button or c.nite button.
¨ Press the "PHOTO Button" when storing confirmed adjuistment value of each adjustment Step in EEPROM.
ˆ The OSD shows "OK" after finishing each adjustment step.
Ø In order to exit the adjustment mode, disconnect the power source.
2) Function of each buttons on the Sst Key
Buttons
PHOTO button push (Confirm)
COLOR NITE (Data Up)
MACRO (Data Down)
EASY-Q (Mode Up)
DISPLAY (Mode Down)
Samsung Electronics
<Table 3-3>
Stores changed value in the adjustment and auto adjustment mode.
Changes data in the adjustment state.
Changes mode.
Alignment and Adjustments
Description
3-3